Cold Storage Room Door Hinge

From the following three aspects can distinguish the good and bad out of the Cold Storage Room Door Hinges:
1.the surface: look at the product surface material is flat, such as seeing scratches and deformation, is produced with waste (edges), the hinge appearance is ugly, so that you have no grade of furniture.
2.hydraulic performance: we all know that the Cold Storage Room Door Hinge is up to the role of a switch, so this is very important, the health of the hinge is taken from the hydraulic hinge damper, and rivets assembly. Damper mainly look at the opening and closing time there is no noise, if there is noise is poor quality products, and look at the round speed is uniform. Is the hinge cup loose? If there is looseness, it proves that the rivets are not riveted tightly and will fall off easily. Close the cup several times to see if the indentation is obvious. If obvious, prove that the thickness of the cup material has a problem, easy to "burst cup".
3.screws: general hinges come with two screws, are part of the adjustment screws, up and down adjustment screws, before and after the adjustment screws, some new hinges with left and right adjustment screws, that is, the so-called three-dimensional adjustment of the hinge, generally with two adjustable workstation enough. Tips, with a screwdriver with a little strength to adjust the upper and lower adjustment screws three to four times, and then take the screws down, look at the hinge arm of the tooth text whether there is damage, because the hinge arm is iron material moulding out of the screws are not so hard, easy to wear and tear, but also due to the factory tapping if the precision is not enough, it is easy to slip the wire, or wringing out of the situation. The front and rear adjustment screws are also tested as these.

Cold Storage Room Door Hinge made in China.
1.Install the hinge cups on the hinge holes of the cabinet door with 2 screws (usually the holes are made beforehand).
2.Mounting the hinge seat to the cabinet side panel.
3.According to the installation of the Cold Storage Room Door Hinges and the cabinet, adjust the door hinges to achieve the most even gap between the door and the cabinet, between the door and the cabinet.
4.Accurate up and down height adjustment is possible with the height adjustable hinged base.
5.After adjusting the gap, the screw holes on the Cold Storage Room Door Hinge should be full of screws to ensure the service life of the Cold Storage Room Door Hinge.

1.superior quality.
2.wide varieties.
3.easy and simple to handle.